HOW TO FLASH CURE CERAKOTE
Flash curing is the process of heating parts in a low temperature oven until they have become tack free, parts will be dry to the touch but not fully cured. This method is used when applying additional layers of Cerakote on top of the base coat. These methods must be followed to ensure chemical adhesion between layers of flash cured Cerakote.We recommend the following flash cure schedules for H-Series and C-Series coatings to get proper adhesion and long-term durability.
H-Series Flash Cure
Oven flash parts for 10-25 minutes between 150°F - 180°F, just to the point of tack free (tack free time will vary, depending on substrate and substrate density).C-Series Flash Cure
Air cure 45 minutes to 1 hour until tack free, (tack free times are varied depending on spraying environment i.e. Humidity & Temperature). Recoat window @ 70°F, 30% humidity is 1-2 hours. Temperature and humidity will affect the drying times.PRO TIP: Check a no show surface for dryness.
Elite Series
We do not recommend layering Elite Series because adhesion may be compromised due to its high chemical resistance.F-Series
We do not recommend flash curing F-Series Coatings.PRO TIP:
Over curing the base coat, when applying multiple coats, may result in poor adhesion and flaking.
Under curing can result in the base coating remaining soft or tacky. If the coating still feels tacky, place back into the oven for 3-5 minutes for additional cure time.
Be sure to always check the Application Guide specific to the product you are using for best results.
For questions, you can reach us at technicalsupport@cerakote.com.
Article Published: August 15, 2025